This doesn't occur everytime, but in some games I don't gain map vision over my villages. In other games I do get the vision normally. Has this been reported yet?

It seems to be 50/50. Upon reloading the game I get the vision properly.

Hello,

I've seen other reports about this.

We will investigate on this but it seems that converted villages by force do not grant vision to the user.

Once again, thanks a lot for all the reports!

No they do, on a reload it works fine, just in some games they don't give vision. I cannot produce a savegame for reproduciton, as in the savegame it worsk as intended. That's the issue.



And I haven't found any similarities yet between the ocurrences.

This game I converted 3 villages, I get the vision properly.



Then the 4th one gets bugged.



---



The third village was one inside my region that I converted. I think that may have something to do with it. I converted outside my region fine, now after I converted inide my region on the 3rd, the 4th had no vision.



The 4th, 5th and 6th are in the same region. They gave me the "Bring 60 dust, then 20 XXX to pacify quest". I destroyed them while the quest was active and converted. The quest never finished.



----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

---- MORE EXACT DETAILS ((( THIS MIGHT BE A SEPARATE BUG REPORT , and it really might not help looking into the original problem. As I believe I also had it with custom races where I have pitiless ))) ---

----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------



1) Parlay quest was given by village1 to go to village 3 with 60dust.

2) Village 1 was attacked and converted.

3) Village 2 was attacked and converted.

4) Parlay on Village 3, gives me part 2 of the quest. To bring 20 Adamanitum to Village 2.

5) Village 2 now shows as a quest marker, even though it is already converted. But yes i have no vision on it.

6) Village 3 is destroyed and converted.



The quest is stuck in my quest as active permanently. Village 2 is highlighted as quest target on the map, but cannot be parlay'ed because it's "already pacified".

I think the quest check might check for destroyed/pacified villages, but not converted villages when checking to eliminate a quest.



------------------



Converted a village after that in another region. Still no vision. Reload fixed it.



---------------



Second village after reload it happened again. First village I converted was okay.

Ok I see.

The problem with the quest not failing/completing is a known issue we still have to look at.

But from what I understand the absence of visibility from a new converted village might also be due to a quest happening or ungoing. I will try to run some test about this.

Thanks for all the additional details.

I've encountered what appears to be the same problem - first play through as the Cultists, 2/4 of my converted villages (both garrisoned with 2-3 units) are dark, and I'm actually unable to get the units out of the villages until I move another unit into the area to grant vision.



Haven't had a chance to re-load the save yet, I'll try tomorrow and see how it goes.